Introduction to CA Anomaly Detector › Get Started with CA Anomaly Detector

Get Started with CA Anomaly Detector

To get started with CA Anomaly Detector 9.3.0, complete the following tasks:

1. Verify that the installation server meets the following requirements and recommendations:
   • Upgrades: Verify that the existing software is supported for upgrade: Software Compatibility
   • Operating System
   • (Recommended) Hardware Specifications.
   • Installation and Upgrade Prerequisites.
2. Verify that a supported version of Performance Center is installed in your environment: CA Performance Center version 2.4/2.3 or CA NetQoS Performance Center 6.1.205 SP2/6.1.194.

   For more information, see the Installation Guide for your Performance Center version.

3. Install or upgrade to version 9.3.0 of CA Anomaly Detector and CA Network Flow Analysis:
   • Install CA Anomaly Detector.
   • Upgrade CA Anomaly Detector.
4. Register CA Anomaly Detector as a data source for Performance Center: Register CA Anomaly Detector.
5. (CA PC deployment) Enable CA Anomaly Detector configuration functions in the NFA console.
6. Add CA Network Flow Analysis and any other products that you want CA Anomaly Detector to monitor: Add Products for CA Anomaly Detector to Monitor.
7. Enable the monitored products so their data is accessible to CA Anomaly Detector: Enable the Monitored Products.
8. Configure the firewalls.
9. (Optional) Review the default sensor configurations and make any necessary changes: Configure the Sensors.
10. (Optional) Configure targets for alerts, so that Syslog or SNMP trap messages are sent when alerts are triggered: Configure Alert Targets.