After you verify that the jobs were identified correctly in Job 1, you can run Job 2.
Refer to the CA07N820 JCLLIB member (from the SYSGEN process) for a sample JCL member. The job also has two steps.
This job performs another iteration against the database much like the first job. The commands in the SYSIN data set for SASSBSTR produce listings for JCL, trigger, and requirement information for each of the jobs to move. Module SASSDT20 examines the BTI output (ddname DT20IN) and produces another card-image data set to be used in Job 3 (ddname DT20OUT).
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|