Using SSM Global Application › How to Set Up SSMGA › Step 10: Activate SSM Processing and Verify the Setup

Step 10: Activate SSM Processing and Verify the Setup

After you make all changes to an existing SSM configuration, you activate SSM processing and then verify that the setup is complete.

Follow these steps:

1. Set the parameter STATEMAN as follows:

   STATEMAN=ACTIVE
   

   The SSM processing is activated.

   Note: SSMGA is not activated until you set the SSMSUBRULE parameter to SSMGAGBL. See Step 4: Set the Parameters, and Using the SSM Subtask.

2. Verify the setup by issuing the VERSYS command from the OPSVIEW 4.11.G panel.

   The SSMGA local setup is validated.