Configuration Parameters › CONFIG Member Parameters › TCPSTACK

TCPSTACK

The job name or started task name of the TCP/IP stack that CA XCOM Data Transport uses. If multiple stacks are running at your site, use this parameter to specify the required stack. The TCP/IP stack that is specified is used for both initiating and receiving transfers.

xxxxxxxx

Specifies up to eight alphanumeric characters indicating the job name or started task name of the TCP/IP stack that CA XCOM Data Transport uses.

Default: None

Notes:

• An empty value causes the CA XCOM Data Transport TCP/IP interface to use every TCP/IP stack running on the system. To use a specific stack, specify the job name of the TCPIP stack.
• The system selects the stack to use.