Configuring and Customizing Your Product › Verify the Installation › Start Your Product

Start Your Product

When you have activated the XCOMXFER server and specified the START parameter, you can start CA XCOM Data Transport.

To start CA XCOM Data Transport

Enter one of the following commands on the z/OS console (or any TSO/ISPF or NETVIEW session) where the user is authorized to invoke z/OS system commands:

• START XCOM
• S XCOM

Several informational messages are displayed when CA XCOM Data Transport is started, as shown in the following example:

XCOMM0890I zIIP PROCESSING HAS BEEN ENABLED                                            
XCOMM0008I XBAS31W  ACB OPENED SUCCESSFULLY                                            
XCOMM0009I COMPILED UNDER VTAM V6 R1 MD - EXECUTING UNDER VTAM V6 R1 MD 5695-11701-1D0 
XCOMM0891I 006 OF 008 STANDARD CPUs ARE ONLINE IN LPAR                                 
XCOMM0891I 003 OF 004 zIIP     CPUs ARE ONLINE IN LPAR                                 
XCOMM0896I zIIP PROCESSING FOR COMPRESSION      IS ENABLED                             
XCOMM0479I TRANSFER QUEUE IS BEING WARM STARTED                                        
XCOMM0037I PSO SUBTASK ATTACHED SUCCESSFULLY                                           
XCOMM0330I PRIMARY SUBSYSTEM IS JES2                                                   
XCOMM0056I CA XCOM(tm) v12.0 (GEN LEVEL 1307 SP00) IS UP AND ACCEPTING LOGONS          
XCOMM0056I ON CPU 2827 SERIAL # 0C4D07 IN 31-BIT MODE MVS SP7.1.3                      
XCOMM1000I STARTING CROSS-SYSTEM COUPLING FACILITY SERVICE TASK                        
XCOMM0027I XCOMSTIM ESTAE ROUTINE HAS BEEN ESTABLISHED                                 
XCOMM0027I XCOMTASK ESTAE ROUTINE HAS BEEN ESTABLISHED                                 
XCOMM0027I XCOMRANX ESTAE ROUTINE HAS BEEN ESTABLISHED                                 
XCOMM1068I CROSS-COUPLING FACILITY LISTENER TASK STARTING                              
XCOMM0027I XCOMRANT ESTAE ROUTINE HAS BEEN ESTABLISHED                                 
XCOMM0803I STARTING XCOM TCP/IP LISTENER                                               
XCOMM0027I XCOMRANQ ESTAE ROUTINE HAS BEEN ESTABLISHED                                 
XCOMM1168I PLEXQ LISTENER TASK STARTING                                                
XCOMM0027I XCOMRANY ESTAE ROUTINE HAS BEEN ESTABLISHED                                 
XCOMM0027I MAINTASK ESTAE ROUTINE HAS BEEN ESTABLISHED                                 
XCOMM1101I CONNECTED TO PLEXQ GROUP PLEXQ1   AS XBAS31W                                
XCOMM0788I XCOM TCP/IP LISTENER ACTIVE ON PORT 06653, STACK ***ALL**                   
XCOMM0819I TCP/IP FUNCTION GETHOSTID RETURNS ADDRESS                      

As it initializes, CA XCOM Data Transport issues one XCOMM0559I message for each member that is enabled, as shown:

XCOMM0559I  AS400   ENABLED SUCCESSFULLY
XCOMM0559I  MVSPAR  ENABLED SUCCESSFULLY

Note: Specifying an unsupported parameter or an invalid value for a parameter results in the CA XCOM Data Transport server terminating. This applies to an EXEC PARM or a Configuration member parameter. A message indicating which parameter caused termination is displayed in the XCOMINIT log.