Previous Topic: Configure CA Spectrum as a Data Source in CA Performance CenterNext Topic: How to Enable CA Spectrum Device Monitoring with CA Infrastructure Management

Introduction: How to Integrate CA Spectrum® and CA Performance Center › How to Integrate CA Spectrum and CA Performance Center › Enable Event Polling in CA Spectrum

Enable Event Polling in CA Spectrum

Enable event polling that takes place between the SpectroSERVER and CA Performance Center. You can specify how often CA Spectrum queries the CA Performance Center Event Manager component for events. Perform this step in the OneClick Administration pages.

Follow these steps:

  1. Click Administration in the OneClick home page.

    The Administration Pages open.

  2. Click Performance Center Integration Configuration in the left panel.

    The Performance Center Integration Configuration page opens.

  3. Enter the desired polling interval, in seconds, in the Event Polling Interval field.

    The default value is 60 seconds. Enter a value greater than or equal to 30 seconds.

  4. Select the Enabled option in the Event Polling field.
  5. Click Save.

    CA Spectrum - CA Performance Center integration is now enabled. The event polling settings take effect on the next polling cycle.