Install Agents › Offline Configuration of Agents to a Different Domain › Create Agent Image

Create Agent Image

You use a batch (ConfigureAgent.bat) file or a shell (ConfigureAgent.sh) file to configure the CA Process Automation agent image to a new domain.

Follow these steps:

1. Install the Domain Orchestrator on the host system.
2. Install an Agent Interactively.
3. Start an Agent.

   The CA Process Automation agent is up and running.

4. Stop an agent.

   The CA Process Automation agent stops.

5. Create a zip file of the agent folder. The zip file is termed as an “agent image”.

   Note: You can configure agents to a different domain based on the following agent images:

   • For agent images of secure agents, you can configure agents to a secure domain only.
   • For agent images of unsecure agents, you can configure agents to an unsecure domain only.
   • For the agent images of the agents that use simplified communication, you can configure agents to use only simplified communication.

     Note: You can make the agents that are configured to use simplified communication to use deprecated communication. For more information, see the Change Agent Configuration from Simplified to Deprecated Communication.

Example

After you install a CA Process Automation agent, the agent installation wizard creates a folder at the following location: <Agent_Installation_Location>/PAMAgent. You need to create a zip file (PAMAgent.zip) of the PAMAgent folder.

Use the agent image to Configure Agents to a Different Domain (or a new domain).