If you installed the MIMTSO load module as a command processor, then you can issue a single CA MIM command as a parameter on a TSO command.
To issue a single command, access the CA MIM command interface, then enter the command.
For example, you can issue a single DISPLAY INIT command to the local system from a TSO ready prompt by specifying this value at the ready prompt:
MIMTSO @DISPLAY INIT
In this example, the at-sign character (@) is the CA MIM command prefix character. Omit the command prefix character if you are running only one copy of CA MIM on this system.
If you also issue a CA MIM command through a CLIST, then the response is returned through a TPUT directive.
Copyright © 2014 CA.
All rights reserved.
|
|