CA MIA Statements and Commands › (MIA) DUMP GTAF/TPCF Command-Create a Dump of GTAF or TPCF

(MIA) DUMP GTAF/TPCF Command-Create a Dump of GTAF or TPCF

CA Technical Support uses the DUMP command for diagnostic purposes for problems that occur with the GTAF or TPCF facilities.

Important! This command is to be used only when you are directed by CA Technical Support to do so.

Scope: Local

This command has the following format:

DUMP {GTAF|TPCF} [{ACEJ |
                 DNE |
                 DLIST |
                 DTOKEL 
                 DVE |
                 FORMAT,dev [,devn ] |
                 GRP |
                 M0AREA |
                 M1AREA |
                 M2AREA}]

ACEJ

Displays the contents of the ACEJ control block.

DNE

Displays the contents of the DNE control block.

DLIST

Displays the contents of the DLIST control block.

DTOKEL

Displays the contents of the DTOKEL control block.

DVE

Displays the contents of the DVE control block.

FORMAT

Displays the contents of the DVE and DLIST control blocks, starting with device dev for the number of devices devn.

GRP

Displays the contents of the GRP control block.

M0AREA

Displays the contents of the M0AREA control block.

M1AREA

Displays the contents of the M1AREA control block.

M2AREA

Displays the contents of the M2AREA control block.

Usage Notes: DUMP GTAF/TPCF Command

• This command is solely intended for use as a diagnostic tool under the direction of CA Technical Support.
• The displays generated by this command are unformatted and not usable if you are unfamiliar with the CA MIA internal control blocks.
• Some operands of this command may cause serious performance degradation of CA MIA and its facilities.

Example: DUMP Command

To dump the contents of the M1AREA control block, issue this command:

DUMP GTAF M1AREA