CA IDMS/DC Messages DC422038 – DC480000 › DC470011

DC470011

<load-module-name> LOAD FAILED: REASON = <code>

Reason:

An attempt to load a control block has failed for the reason specified. The control blocks are:

• ADSOOPTI (or a site specified synonym) created by program ADSOBSYS and containing system generation parameters.
• $ACF@TAT created by the application compiler and containing a list of valid task codes and corresponding application names.
• The Application Definition Block (ADB) whose name matches the name of the application being executed, created by the application compiler and containing the application definition parameters.

The reason codes for the load failure are as follows:

• SNGL = the module is defined as nonconcurrent and is currently in use.
• PGNF = the module cannot be found.

This message is not accompanied by an ABEND dump. Rerun the job after making appropriate corrections. For SNGL, either wait until the module is no longer in use or redefine the module as concurrently usable. For PGNF, either correct the module name as found on the JCL or the SYSIPT data set or run the appropriate utility to create the module.

Module:

ADSORUNB

Severity:

0