CA RiskMinder Windows Installation Guide › Upgrading RiskMinder › Database Privileges Required for Upgrade › Reinstalling RiskMinder › Reinstalling RiskMinder on a Single System

Reinstalling RiskMinder on a Single System

Perform the tasks that are described in the following sections to reinstall RiskMinder on a single system:

1. Install RiskMinder.

   Note: When you install release 3.1, ensure that you specify the same primary and backup database details from arcotcommon.ini in the %ARCOT_HOME%\conf\ directory.

2. Verify the database setup.
3. Prepare the application server.
4. Deploy Administration Console.
5. Log in to Administration Console.

   Important! Ensure that you use the current MA password and not the default password, because the MA password has been reset during the bootstrap process that you performed during 2.x installation.

6. Start the RiskMinder Server.
7. Start the Case Management Queuing Server.
8. Verify the installation.

   Note: If there are any warnings during the Server startup and if your transactions fail, then the upgrade has not been performed successfully. You can revert to your initial setup by following the steps that are listed in (In Error Scenario Only) Reverting to Your Initial Setup.

9. Deploy User Data Service.
10. Deploy Sample Application.
11. Use the Sample Application to test the migration by verifying whether the user accounts and the related data from the earlier setup have been successfully migrated to the new database.
12. Apply the post-installation checklist.