CA RiskMinder UNIX Installation Guide › Deploying RiskMinder On a Single System › Performing Post-Installation Tasks › Starting the Case Management Queuing Server

Starting the Case Management Queuing Server

To start Case Management Server:

1. If the required environment variables have not been set, run the following command:

   source <install_location>/arcot/sbin/arrfenv
   

   In this command, replace <install_location> with the path of the directory in which RiskMinder has been installed.

2. Navigate to the following directory:

   install_location/arcot/bin/
   

3. Run the ./casemanagementserver start command.

   Note: If you want to stop Case Management Server, then navigate to the bin directory and enter the ./casemanagementserver stop command.