Command Reference › set

set

The set command changes grid parameters.

This command has the following format:

aldo set grid= name [opt=val...] [ file= cfgfile] [ controller_ip= ] [ controller_name= ]

grid= name

Specifies the name of the grid to reconfigure.

controller_ip= ipaddr or controller_name= host

Specifies the IP address or host name of the controller. One of the two must be specified and referring to the controller external IP address. This value is not required if the grid was installed or reconfigured from the same distribution server on which the set command is being run. Because controller_ip, controller_name, or both are used to identify the grid, to change these parameters, use the prefix new_ for the new value. See Configuration Options.

opt=val

Specifies new settings to apply to the grid servers. All configurable parameters except impex_vol_mb can be changed with the aldo set command (see Configuration Options).

Remarks

Any parameters that are not specified on the command line or in the file= configuration files remain unchanged.