Starting Your Product › How to Configure Without CA CSM › Install the ISPF Interface

Install the ISPF Interface

(Optional) This procedure installs the CA 1® Tape Management ISPF interface. If you do not use the ISPF interface, proceed to the next section.

The CA 1® Tape Management ISPF libraries are loaded onto disk during installation. All CA 1® Tape Management ISPF interface modules are contained in the CA common load library. To install the CA 1® Tape Management ISPF subsystem, modifications are made to your ISPF main menu panel, and possibly to your TSO PROC.

To install the ISPF interface by modifying the TSO users logon procedure

1. Open ISR@PRIM in the first library in the ISPPLIB concatenation.

   ISR@PRIM can be edited.

2. Insert the following line into the screen definition:

   %n + CA 1® Tape Management ISPF - CA 1® Tape Management ISPF subsystem
   

3. Insert the following line into the PROC definition:

   n,'PGM(TMSIOPRI) NOCHECK NEWAPPL(TMS)'
   

   n

   Specifies the main menu option to invoke CA 1® Tape Management ISPF.

   ISPF is added to the menu.

To install the ISPF interface by adding an optional CLIST

This CLIST dynamically allocates the required libraries (except the load modules) using the LIBDEF facility of ISPF.

1. Open ISR@PRIM in the first library in the ISPPLIB concatenation.

   ISR@PRIM can be edited.

2. Insert the following line into the screen definition:

   %n + CA 1® Tape Management ISPF - CA 1® Tape Management ISPF subsystem
   

3. Insert the following line into the PROC definition:

   n,'CMD(TMSISPF) NOCHECK NEWAPPL(TMS) PASSLIB'
   

   n

   Specifies the main menu option to invoke CA 1® Tape Management ISPF.

   CLIST invokes the CA 1® Tape Management ISPF subsystem.

Note: A sample CLIST is provided in hlq.CTAPCLS0(TMSISPF).