Starting Your Product › How to Configure Without CA CSM › Enable the ISPF Tape Inquiry (TI) Command

Enable the ISPF Tape Inquiry (TI) Command

The Tape Inquiry Command (TI) enables users to display information about CA 1® Tape Management controlled volumes cataloged in the z/OS catalog without starting up the full CA 1® Tape Management ISPF interface. The TI command is issued from the ISPF DSLIST (3.4) command line.

To enable the TI command

1. Copy the ISPF panels TMPITTIG, TMPTTIH, TMPTTIH1, TMPTTIH2, and TMPTTIH3 from hlq.CTAPPENU to your ISPF panel library.
2. Copy message number CMGA00 from hlq.CTAPMENU to your ISPF message library.
3. Copy the CLIST member TI from hlq.CTAPEXEC to your CLIST library and edit the member to reflect the data set names in use at the time of installation.
4. Do one of the following:
   • If the CA target load library hlq.CTAPLINK is in the LNKLST, copy load module CTSTI to a LNKLST data set.
   • If the CA target load library hlq.CTAPLINK is not in the LNKLST copy load module CTSTI to the CA target library provided in the TSO logon JCL.

JCL is provided in hlq.CTAPCLS0(TMSISPF).