The Batch Interface › PARM Parameters › REPCR

REPCR

Specifies whether CA XCOM Data Transport is to attempt to do a CREATE when receiving a transfer with FILEOPT=ADD|REPLACE and the data set does not exist.

YES

Specifies that CA XCOM Data Transport will attempt to do a CREATE when receiving a transfer with FILEOPT=ADD|REPLACE and the data set does not exist.

NO

Specifies that CA XCOM Data Transport will fail the transfer when receiving a transfer with FILEOPT=ADD|REPLACE and the data set does not exist.

Default: NO

Notes:

• The REPCR default parameter can be specified in the default table or overridden by the XCOMJOB/XCOMXFER EXEC parameter.
• The value of REPCR can also be modified using the operator DFLT command.