The Batch Interface › SYSIN01 Parameters › General SYSIN01 Parameters › USERID

USERID

Identifies the user ID that CA XCOM Data Transport is to use on the remote system. The user ID must be known to the remote system's security.

xxxxxxxxxx

Specifies a user ID (up to 12 alphanumeric characters) whose access privileges on the remote system are to be used for this file transfer.

Notes:

• For IBM iSeries or OpenVMS, specify the user's signon. If this parameter is omitted, CA XCOM Data Transport defaults to the ID associated with the address space that submitted the file transfer request.

  For example, if there is a JCL USERID parameter coded in the JOB statement of the job invoking XCOMJOB, then that JCL USERID is used. If a blank USERID parameter value is to be sent to the remote system, USERID=“ ” must be entered, with at least one space between the quotes. Do this if the remote system is to supply its own default for the user ID under whose access privileges this transfer is to execute.

• You can use symbolic variables with this parameter in batch SYSIN01. For more information, see Symbolic Parameters.