Previous Topic: XCOMPLEX

Next Topic: SYSIN01 DD Statement

The Batch Interface › SYSIN01 Parameters

SYSIN01 Parameters

This section describes the set of parameters that are specified in the SYSIN01 DD statement of the XCOMJOB JCL. The discussion of the SYSIN01 parameters is divided into the following subsections:

Symbolic Parameters

This section discusses parameters with variable data that is resolved to other values at schedule time or at transfer time, depending on the specific parameter

General SYSIN01 Parameters

This section discusses parameters that can be specified in any batch job.

SYSIN01 Parameters Required by FILETYPE=FILE

This section discusses parameters that must be used when FILETYPE=FILE is coded in the SYSIN01 DD statement).

SYSIN01 Parameters Required by FILETYPE=REPORT

This section discusses parameters that must be used when FILETYPE=REPORT is coded in the SYSIN01 DD statement).

SYSIN01 Tape Parameter

This section discusses parameters that need to be used when tape data sets are being transferred.

SYSIN01 DCB Parameters

This section discusses parameters that are used to allocate space for transferred data.

SYSIN01 Transfer Control Parameters

This section discusses parameters associated with CA XCOM Data Transport's transfer control (XTC) feature, which is concerned with the control of multiple interdependent transfers.

Note: There are no special parameters required for FILETYPE=JOB.