|
|
|
To start CA XCOM Data Transport, enter one of the following commands on the z/OS console (or any TSO/ISPF or NETVIEW session) where you are authorized to invoke z/OS system commands:
START XCOM
S XCOM
Several informational messages are displayed when CA XCOM Data Transport is started—see the following example:
XCOMM0672I CA XCOM (TM) DATA TRANSPORT (R) r11.6 GENERATION LEVEL 0712 SP00 XCOMM0004I START=$XCMVS4 XCOMM0004I DFLTAB=XC04B50X XCOMM0004I TCPSTACK= XCOMM0890I zIIP PROCESSING HAS BEEN ENABLED XCOMM0008I XCOMMVS4 ACB OPENED SUCCESSFULLY XCOMM0009I COMPILED UNDER VTAM V6 R1 MC EXECUTING UNDER VTAM V6 R1 MC 5695 117 XCOMM0891I 006 OF 008 STANDARD CPUs ARE ONLINE IN LPAR XCOMM0891I 004 OF 004 zIIP CPUs ARE ONLINE IN LPAR XCOMM0896I zIIP PROCESSING FOR COMPRESSION IS ENABLED XCOMM0479I TRANSFER QUEUE IS BEING WARM STARTED XCOMM0027I ESTAE ROUTINE HAS BEEN ESTABLISHED XCOMM0037I PSO SUBTASK ATTACHED SUCCESSFULLY XCOMM0056I CA XCOM(TM) r11.6 (GEN LEVEL 0712 SP00) IS UP AND ACCEPTING LOGONS XCOMM0056I ON CPU 2097 SERIAL # 01E000 IN 31-BIT MODE MVS SP7.0.9 XCOMM0330I PRIMARY SUBSYSTEM IS JES2 XCOMM0330I PRIMARY SUBSYSTEM IS JES2 IPV6/SSL XCOMM0821I STARTING XCOM TCP/IPV6 SSL LISTENER IPV4/SSL XCOMM0806I STARTING XCOM TCP/IP SSL LISTENER IPV4 XCOMM0803I STARTING XCOM TCP/IP LISTENER IPV6 XCOMM0820I STARTING XCOM TCP/IPV6 LISTENER
After these messages have been displayed, the CA XCOM Data Transport server begins scanning through the destinations that the CA XCOM Data Transport control library specifies. It is also ready to accept incoming requests from remote systems
While it initializes, CA XCOM Data Transport issues one XCOMM0559I message for each member that is enabled, as shown in the following example:
XCOMM0559I AS400 ENABLED SUCCESSFULLY XCOMM0559I MVSPAR ENABLED SUCCESSFULLY
| Copyright © 2012 CA. All rights reserved. |
|