|
|
|
To gather information about the XCOMPLEX, issue the STAT MODIFY command (see Using the CA XCOM Data Transport MODIFY Commands in the chapter “Operation and Control” in the CA XCOM Data Transport for z/OS User Guide). The output of this command verifies that the XCOMPLEX is in communication with the Coupling Facility and validates the installation and configuration of the XCOMPLEX Admin Servers and XCOMPLEX Worker Servers. This information is displayed in the XCOMLOG.
If there is no response from the STAT command, verify that the XCOMPLEX parameter is set correctly for each XCOMPLEX Worker Server in the XCOMPLEX, by checking the value for that parameter in the XCOMLOG when the server comes up.
To gather information about the PLEXQ, issue the STAT MODIFY command (see Using the CA XCOM Data Transport MODIFY Commands in the chapter Operation and Control in the CA XCOM Data Transport for z/OS User Guide). The output of this command verifies that the PLEXQ is in communication with the SYSPLEX signaling services and validates the installation and configuration of the PLEXQ group servers. This information is displayed in the XCOMLOG.
Verify that the PLEXQ parameter is set correctly for each Worker Server in the PLEXQ group if there is no response from the STAT command. Check the value for the parameter in the XCOMLOG when the server comes up to verify that the PLEXQ parameter is set correctly. Also verify that the server is connected to the PLEXQ by checking the XCOMLOG for message XCOMM1101I CONNECTED TO PLEXQ GROUP xxxxxxxx.
| Copyright © 2012 CA. All rights reserved. |
|