Installing CA XCOM Data Transport for HP-UX IA64 › Upgrading or Reinstalling › Shutting Down

Shutting Down

This section describes how to shut down CA XCOM Data Transport for HP-UX IA64 before performing an upgrade or a reinstall.

Notes:

• Log on as superuser (root), or be a member of the xcomadm group, to perform this procedure.
• The CA XCOM Data Transport for HP-UX IA64 daemon must still be running to execute the command in Step 1.

Important! The command in Step 1 removes all transfer entries that are active.

To shut down

1. At the command line, enter the following command:

   xcomqm -Rf*
   

   All queue entries are deleted.

2. If xcomtool or the GUI (r11.5 only) is active, close xcomtool. To close xcomtool, click in the Main window and selecting Quit from the menu bar and close the GUI by clicking the X in the upper right hand corner.
3. Enter the following command:

   xcomd -s
   

   CA XCOM Data Transport for HP-UX IA64 shuts down, and the following messages are displayed:

   XCOMU0079I xcomd: stop requested.

   XCOMU0082I xcomd: stop request accepted.

   Note: If you are working from the console, a message similar to the following also displays:

   2009/02/22 17:08:49 PRG=XCOMD PID=22189 XCOMU0089I xcomd ended.