SPO0 - XTRK Messages › SPO0 Through SPO9 › SPO7-02

SPO7-02

JOB xxxxxxxx NOT FOUND IN JOB DATA SET

Reason:

The requested job (member) may not have been found in the CA Workload Automation SE Job data set.

Action:

Several conditions could cause this message to be issued:

• Verify the job name specified on the input request. If it is invalid, correct and reenter the command.
• The Schedule statement may be missing from the initialization file and therefore jobs cannot be submitted.
• If there is a Schedule statement, check the HIJBNUM parameter. The high job number may have been reached. If this is the case, CA Workload Automation SE cannot add jobs (or networks) to the queue until a number becomes available or the HIJBNUM value is increased. To increase the value, bring CA Workload Automation SE down with a DMPQ, change the value in the initialization file, and bring CA Workload Automation SE back up with a TYPE=COLD or MOVQ.
• An operator may not have the correct user ID authorization to access the job.
• The request queue does not have enough space to add the job.