CA-7.A - CA-7.X Messages › CA-7.D32V Through CA-7.VDB0 Messages › CA-7.SVCT000E

CA-7.SVCT000E

INDICATOR BYTE NOT SET.

Reason:

The code indicating that the job was submitted by CA Workload Automation SE was not found at the location in the SMF Common Parameter Area that was specified on the GLOBAL INIT statement in the System Configuration File. This may indicate a tracking error.

Action:

Make the appropriate corrections in case:

• The U7TESTSV job was not demanded by CA Workload Automation SE.
• Column 71 of the first JOB statement has been modified or columns 70/71 are not blank.
• There is a conflict over the use of either the USERID field or the RDRTIME field in the SMF Common Parameter Area so that the CA Workload Automation SE indicator byte has been overlaid (probably by another UJV exit).
• The CA Workload Automation SE UJV exit is not getting control. This may occur if the IEFUJV exit is not linked properly.