Batch Processing › SARBCH Control Statements › BPRINT

BPRINT

The BPRINT control statement reprints a CA Deliver bundle that is archived to the CA View database.

Syntax:

/BPRINT  BANNER=(bundle-banner,dist-banner,report-banner)
         BCONT=(dist-id,((report-id,gen,seq),…),…)
         BDIST=dist-id
         BID=bundle-id

where:

BANNER=
(bundle-banner,
dist-banner,
report-banner)

Specifies the model banner page names of the bundle, distribution, and report banner pages.

The model banner page name can be omitted. If omitted, the model banner page name defined to the bundle in the CA Deliver database is used. An asterisk suppresses the printing of the model banner page.

This parameter is optional.

BCONT=(dist-id,
((report-id,gen,seq),
…),…)

Specifies the distribution identifiers and archived reports that comprise the bundle.

• The bundle print is produced in the exact sequence as specified in this parameter.
• One or more distribution identifiers can be specified, each followed by a complete list of report identifiers, generation number, and sequence number.
• The generation number and sequence number can be specified as an absolute or a relative number.

If a report in the bundle being reprinted utilizes the ARCHID alternate report name in the CA Deliver definition, specify this name for the report-id field.

• If omitted, the most recently archived report is used.
• This parameter is required.

Note: If report-id or dist-id contains an embedded blank, parentheses, quotes, equal signs, or commas, it must be enclosed in single quotes.

BDIST=x

Specifies the distribution identifier from which the distribution banner-page instructions are to be taken.

If omitted, the bundle distribution identifier defined to the bundle in the CA Deliver database is used. If the bundle distribution identifier in the CA Deliver database is omitted, the first identifier defined in the BCONT parameter is used.

BID=bundle-id

Specifies the name of the bundle to be printed.

This parameter is required.

Note: You can use the CA View OUTLIM initialization parameter to limit the number of printed lines. See the Initialization Parameters chapter for more information.