Using the Optical Disk Interface › Configuring the Optical Disk Interface › Step 2: Configure the Page-Level Drivers › Adding the MOUNT Attribute: Kodak Optistar Report Level Driver Only

Adding the MOUNT Attribute: Kodak Optistar Report Level Driver Only

This step is optional. Because the Kodak Optistar optical disk device appears to the system as a tape device, the emulated tape volumes must be mounted before being accessed.

If you are using the report-level driver and you intend to allow TSO users to access SYSOUT groups on optical disk storage, you must assign the mount attribute to those TSO users. Consult your optical disk device documentation for possible alternatives to setting the mount attribute.

Note: The Kodak Optistar page level driver uses the services of MDRS, which performs the mounts automatically for the TSO user. Do not assign the mount attribute for users of the page-level driver.

The TSO ACCOUNT command can be used to assign the mount attribute as follows:

ACCOUNT
C (user ID) MOUNT
END