Using the Optical Disk Interface › Configuring the Optical Disk Interface › Step 2: Configure the Page-Level Drivers › DSK2PARM: Kodak Optistar Report Level Driver

DSK2PARM: Kodak Optistar Report Level Driver

Specify the unit name of the optical disk for UNIT. The syntax is as follows:

Syntax:

DSK2PARM=unit/volser1/volser2

Notes:

Specify the lowest volume serial number in the range as volser1 and the highest volume serial number in the range as volser2.

The serial numbers for the range of emulated tape volumes must be the same length, must end with one or more digits, and must have matching beginning alphabetic characters (if any).

• Whenever a new emulated tape is required for archival, the next tape in the range is used.

  When the end of the range is reached, the first tape in the range is used.

• The range of emulated tape volumes must already be defined and initialized within the optical disk device.