Printing Output › Online and Batch Printing—P and J Commands › Using the P and J Commands › ALL and SARO Modes › J Command

J Command

When you use the J command in ALL or SARO mode, a batch job is created to print the output you specify. The job is submitted when you exit the product or issue the SUBMIT command.

1. In the Sysout Selection List, enter J in the Select column of the output you want to print, and then press Enter to display the main Print Attribute panel.

   Note: For more information about this panel, see the section Main Print Attribute Panel later in this chapter.

2. Verify or change the print attributes in the main Print Attribute panel, and then do one of the following:
   • To print from this panel, press Enter.

     The output is queued for printing.

   • To print from an optional printer panel, go to Step 3.
3. In the main Print Attribute panel, do one of the following:
   • To print on the primary optional printer, enter P on the command line, press Enter to display the primary printer panel, then go to Step 4.
   • To print on the alternate optional printer, enter A on the command line, press Enter to display the alternate printer panel, then go to Step 5.
4. In the primary printer panel, press Enter to queue the output for printing.
5. In the alternate printer panel, press Enter to queue the output for printing.
6. Do one of the following to submit the batch print job:
   • Issue the SUBMIT command.
   • Exit CA View.
7. When the Batch Card JCL panel appears, verify the JOB statement information.