Printing Output › Online and Batch Printing—P and J Commands › Using the P and J Commands › ALL and SARO Modes › P Command

P Command

To print output in ALL and SARO modes with the P command, follow these steps:

1. In the Sysout Selection List, enter P in the Select column of the output you want to print
2. Press Enter to display the main Print Attribute panel.

   Note: See the section Main Print Attribute Panel later in this chapter for more information.

   CA View ALL --------------- Print Attribute Panel ----------------  
   Command ===>                                                                   
                                                                                  
      ID     ---> SWILAROG                                                       
      Job    ---> SWILAROG    Jobid  ---> JOB05739        
                                                                                   
   Print Attributes:                                                              
      BANNER ===> DEFAULT      CLASS  ===> 3           DEST   ===> LOCAL         
      COPIES ===> 1            BURST  ===> N           FORM   ===> STD             
      FCB    ===>              OPTCDJ ===> N           FLASH  ===> (      ,     )  
      UCS    ===>              HOLD   ===> N           MODIFY ===> (      ,   )    
      FORMDF ===>              PAGEDF ===>             PRMODE ===>                 
      LINECT ===>              VIEW   ===>             PRTY   ===>                 
      CHARS  ===> (      ,      ,      ,      )        WRITER ===>                 
      COPYG  ===> (     ,     ,     ,     ,     ,     ,     ,     )                
      PAGE   ===>                                                                  
      RECORD ===>                                                                  
                                                                                   
                Press ENTER to confirm or enter END command to cancel             
   

3. Verify or change the print attributes in the main Print Attribute panel, then do one of the following:
   • If you want to print from this panel, press Enter to process the output online.
   • If you want to print from an optional printer panel, go to Step 4.
4. In the main Print Attribute panel, do one of the following:
   • To print on the primary optional printer, enter P on the command line, press Enter to display the primary printer panel, then go to Step 5.
   • To print on the alternate optional printer, enter A on the command line, press Enter to display the alternate printer panel, then go to Step 6.
5. In the primary printer panel, validate the print attributes, then press Enter to process the output online.
6. In the alternate printer panel, validate the print attributes, then press Enter to process the output online.