SAR(O) Selection Codes

Selecting and Retrieving Reports › Selecting SYSOUT for Retrieval—SAR(O) Mode › SAR(O) Selection Codes

SAR(O) Selection Codes

The following table lists and describes all selection codes that are valid for use in SAR or SARO mode. In all cases, the CA View action is taken on the output ID displayed on the line in which the selection code is entered.

Action	Selection Code	What the Product Does
Migrate	M	Migrates the output to optical disk with the next backup cycle
Print SARO mode	P	Prints the SYSOUT using the Print Attribute panel. Enter A on the command line to display the Print Attribute alternate panel.
	PI	Prints the index data for a report using the Print Index panel. You can enter print attributes for the SYSOUT data set on this panel.
	J	Creates JCL for a background job to print the SYSOUT using values from the Print Attribute panel. Enter A on the command line to display the Print Attribute alternate panel.
	JI	Creates JCL for a background job to print index data for a report using the Print Index panel. You can enter print attributes for the SYSOUT data set on this panel.
Print SAR mode	P	Prints the SYSOUT using the Print Attribute primary panel
	PA	Prints the SYSOUT using the Print Attribute alternate panel
	PI	Prints the index data for a report using the Print Index panel. You can enter print attributes for the SYSOUT data set
	J	Creates JCL for a background job to print the SYSOUT using values from the Print Attribute panel
	JA	Creates JCL for a background job to print the SYSOUT using values from the Print Attribute alternate panel
	JI	Creates JCL for a background job to print index data for a report using the Print Index panel. You can enter print attributes for the SYSOUT data set on this panel.