|
|
|
By default, the SystemEDGE agent does not allow SNMP Set requests on the following tables in the Systems Management Empire MIB and Host Resource MIB:
Permits management systems to remotely instruct the agent to run shell scripts and programs on the agent system when enabled. The disclosure of this type of information can post a potential security risk.
Note: For more information about this group, see the chapter "Systems Management Empire MIB."
Permits access to processes and other software running on agent systems. Consider security risks when allowing SNMP SET requests on these tables.
Note: For more information about the Process table, see the chapter "Systems Management Empire MIB." For more information about the Running Software table, see the appendix "Host Resources MIB."
You can enable SNMP Sets to these tables, assuming that queries use a valid community with read-write permissions for SNMPv1 and SNMPv2c communication or valid SNMPv3 user credentials for SNMPv3 communication.
To enable support for SNMP Sets on the Remote Shell group, comment out the following line in the sysedge.cf file by adding a pound sign character (#) as follows:
# no_remoteshell_group
To enable support for SNMP Sets on the Process and Running Software tables, comment out the following line in the sysedge.cf file by adding a pound sign (#) character as follows:
# no_process_sets
You can also remove the lines completely.
| Copyright © 2013 CA. All rights reserved. |
|