Configure Power: Microsoft Hyper-V
The Configure Power action type controls the startup and shutdown of a virtual machine in your Hyper-V environment.
The Details section of the action definition contains the following fields:
Specifies the name of the server on which Hyper-V Server resides. Select one from the drop-down list.
Specifies the name of the virtual machine for which to change the state. Select one from the drop-down list.
Specifies the action to perform when the Hyper-V Server starts. Select one of the following from the drop-down list:
Always starts the VM when the Hyper-V Server starts.
Automatically starts the VM when the Hyper-V Server starts.
Does not start the VM when the Hyper-V Server starts.
Adjust the delay (in seconds) to start a VM after the Hyper-V Server starts. Select one from the drop-down list.
Specifies the action to perform when the virtual machine shuts down. Select one of the following from the drop-down list:
Turns off the VM before Hyper-V Server shuts down.
Saves (Suspends) the VM before Hyper-V Server shuts down.
Shuts down the VM before Hyper-V server shuts down.
Specifies the action to regain the previous details of a virtual machine when the Hyper-V Server fails. Select one of the following from the drop-down list:
Does not take a specific action when the Hyper-V Server starts after the server fails.
Restarts the VM when Hyper-V Server starts after the server fails.
Reverts the VM with the latest snapshots when the Hyper-V Server starts after the server fails.
Select to specify that the ticket requires approval by a third party.
Note: CA SDM must be configured to use this option.
Select to close the ticket after it is approved or rejected.
Note: CA SDM must be configured to use this option.
Select a valid ticket type from the drop-down list. Depending on your configuration, valid types include:
Note: CA SDM must be configured to use this option.
Specifies the template to use to create a ticket. Select a template from the drop-down list. Depending on the ticket type selected, the form is populated with corresponding values.
Note: CA SDM must be configured to use this option.
Copyright © 2013 CA. All rights reserved. |
|