Part two of the CA-PanAPT Move Request processing is generation of the move JCL from the Models. This is done by job APJJ5320, which reads the cataloged file created by the Select Job APJJ5310 and, using the CA‑PanAPT Models, generates the necessary JCL and control statements to process the entities in each selected Move Request. The generated job streams can then be scheduled and run according to your site's requirements (see the two diagrams shown earlier).
Note: The CA-PanAPT Batch Move process is normally scheduled and runs at regular times.
For instance, your site might choose to perform the Selection process (APJJ5310) every day at 1:00 p.m. The actual Moves (APJJ5320) could be done every day at 4:00 p.m. The reports from the Selection process should be reviewed, and if corrections are necessary, they would be made, and the Selection process could be rerun before APJJ5320 runs.
The distributed JCL for APJJ5320 submits the generated JCL immediately after performing the modeling.
|
Copyright © 2004 CA.
All rights reserved.
|
|