This section contains the following topics:
Starting CA PMO Automatically at IPL Time
The CA PMO load library must be APF-authorized. You can authorize the library by specifying it in the IEAAPFxx member of SYS1.PARMLIB.
If you are using the PMO/XSYS option, you must format the control file when you start CA PMO for the first time after installation. You must reformat the control file every time you change the value of the XSYS parameter in your parameter data set.
Enter the following command on one system that runs CA PMO:
S started_task_name,FORMAT=YES
When CA PMO starts, it responds:
PMO001I CA PMO 4.4 ACTIVE
When PMO/XSYS becomes active on that system, it responds:
PMO701I PMO/XSYS 4.4 ACTIVE
When PMO/XCF becomes active on that system, it responds:
PMO801I - PMO/XCF 4.4 ACTIVE)
As an alternative to starting CA PMO by issuing a start command at the console, you can allow CA PMO to start automatically when you IPL your system.
On all systems that run CA PMO, add the CA PMO start command to the IPL commands in SYS1.PARMLIB(COMMNDxx).
|
Copyright © 2011 CA.
All rights reserved.
|
|