Installation and Configuration Considerations for PLEXSSM

Following are the steps required to install and configure the sysplex resource monitor for the PLEXSSM sample program:

Start CA OPS/MVS, and then run the PLEXSSM REXX EXEC to build the following RDF tables:
- PLEXRTBL-sysplex resource table
- PLEXATBL-sysplex resource action table
- STAPRTBL-STAPE resource table
- STAPATBL-STAPE resource action table
Copy the PLEX* and STAP* rules to the active rule set and set the auto-enable option:
- SSMBEGIN-Includes modifications to set the DESIRED state of sysplex resources
- PLEXINIT-Rule that executes to set the current state when sysplex resources are in the UNKNOWN state
- PLEX*ARM-Rules to maintain the status of ARM resources
- PLEX*ASW-Rules to maintain the status of auto-switch resources
- PLEXCFRM-Rules to maintain the status of CFRM resources
- PLEXETR-Rules to maintain the status of ETR resources
- PLEXGRS-Rules to maintain the status of GRS resources
- PLEX*LOG-Rules to maintain the status of LOGGER resources
- PLEXSFM- Rules to maintain the status of SFM resources
- PLEXWLM-Rules to maintain the status of WLM resources
- PLEX*XCF-Rules to maintain the status of XCF resources
- PLEX*XES-Rules to maintain the status of XES resources
- STAPINIT-Rules that execute to populate the STAPRTBL and STAPATBL tables and set the current state when STAPE resources are in the UNKNOWN state
- STAP*ASW-Rules to maintain the status of the individual STAPE devices