Configuring and Installing Optional Components › Configuration Tasks for Optional Base Components › Set up the Interface with CA 7 WA › Access the CA 7 Browse Log
Access the CA 7 Browse Log
You must add a data control module (DCM) to the ENF database to access the CA 7 WA Browse log.
To access the CA 7 WA browse log
- Install CA 7 WA Release 3.3 or higher.
- Set the CA OPS/MVS INITCA7 parameter to YES in the OPSSPA00 member. If you want CA OPS/MVS to generate ENF-related trace messages, then you must also set the CA OPS/MVS DEBUGENF parameter to YES. Additionally, depending on the volume of browse messages that CA 7 WA produces, you may need to tailor the default values of the CAIENFMAX and CAIENFRATE parameter. For more information on these parameters, see the Parameter Reference.
- Add the DCM to ENF. Verify with CA 7 WA Technical Support that their SAMPJCL contains an L232DCM1 job.
This job installs the CA 7 WA browse event. An ENF EVENT command listing all of the DCMs that are installed should display:
DCM module name: CAL2DCM1 Description: CA 7 BROWSE EVENT Installed
date: 01.010 time: 11:25:20
Copyright © 2014 CA Technologies.
All rights reserved.
|
|