![Previous Topic: Connectivity Control Commands](574.png)
![Next Topic: ACTIVATE Command—Sets Connection Status](573.png)
Switch Operations Facility › SOF Server Commands › Connectivity Control Commands › Limit the Operation of Connectivity Control Commands
Limit the Operation of Connectivity Control Commands
In some cases, you may only want to see what VARY operations an SOF command would perform, without actually executing the operations. For that purpose, SOF connectivity control commands support the NOEXEC parameter, which prohibits execution of all operations.
SOF connectivity control commands also support the following parameters to control or limit specific aspects of their operation:
- NOVARY parameter, which prevents all VARY ONLINE processing for both paths and devices.
- BACKOUT parameter, which reverses all VARY processing in case of failure.
- FORCE parameter, which ignores any VARY failures.
- TIMEOUT parameter, which limits the amount of time allowed for the command to fully complete execution.
- MAXDEVICES parameter, which limits the number of devices that may be affected by the command.
- NOVARYDEV parameter, which prevents all VARY ONLINE and VARY OFFLINE processing for devices only.
Note: For detailed descriptions of these parameters, see the DEFAULTS command.
Copyright © 2014 CA Technologies.
All rights reserved.
![Previous Topic: Connectivity Control Commands](574.png) ![Next Topic: ACTIVATE Command—Sets Connection Status](573.png)
|
|