Depending on the command you want to issue, you will be required to enter additional parameters.
ActivationProfile-The name of the activation profile that you want to use to activate the CPC. If you want to use the default value, you can specify ActivationProfile().
Attribute-The name of the attribute that you want to get or set the value for.
Value-The value to be assigned to the attribute.
OrderNumber-The order number of the On/Off on Demand (On/Off CoD) record to be activated.
LPAR-The name of the LPAR on which you want to work.
ClearMemory(YES|NO)-Specifies whether to clear memory before performing the Load action. There is no default.
LoadAddress-The hexadecimal address to be used when performing the Load action. The default value is the last address used when a Load action was performed for the object. To use the default value, specify LoadAddress().
LoadParm-The parameter string to be used when performing the Load action. The default value is the last parameter used when a Load action was performed for the object. To use the default value, specify LoadParm().
StoreStatus(YES|NO)-Specifies whether the status should be stored before performing the Load action. There is no default.
Timeout-The amount of time (in seconds) to wait for the Load action to complete. There is no default
OpCommand-Specifies the operator command that you want to issue on the LPAR. Sending a blank OpCommand parameter repeats the previously sent command.
Priority(YES|NO)-Specifies whether the command is a priority operating system command. There is no default.
Copyright © 2014 CA Technologies.
All rights reserved.
|
|