The following parameters are required:
Specifies the CPC and LPAR actions to perform. See the list of supported CPC and LPAR actions above.
Specifies the community name of the workstation that is running the SE/HMC application.
Specifies the name of the CPC.
Specifies the IP address of the workstation that is running the SE/HMC application.
Specifies the order number of the On/Off Capacity on Demand (On/Off CoD) record to be activated. This parameter is required on the CPC action Activate_OOCOD.
If you have only one SE/HMC workstation or CPC, there are sections at the beginning of the OPSHMC program that allow you to set default values for the Community, CPC, and Target parameters. If you set default values, you do not have to specify the parameters; however, you can still override the defaults by specifying the keywords and override values.
Note: If you plan to modify the OPSHMC program, CA recommends that you make a backup copy of the version that was shipped with CA OPS/MVS.
|
Copyright © 2014 CA Technologies.
All rights reserved.
|
|