Customizing CA Network Flow Analysis › Create Protocol Groups › Review the Protocol Group Settings

Review the Protocol Group Settings

After you create a protocol group and operators run reports that use the protocol group as a filter, you may want to make changes.You may want to rename the protocol group to reflect the way operators are likely to use it. You also may want to change the list of protocols included in the group.

Follow these steps:

1. Select the protocol group from the ‘Select a Protocol Group’ list on the Protocol Group Configuration page.
2. (Optional) Edit the name or description of the protocol group:
   1. Click Edit.

      The Edit a Protocol Group page opens.

   2. Change the values for the Group Name and Description fields to help identify the purpose of the protocol group more clearly.
   3. Click Submit.

      The name and description are updated in the Protocol Group Configuration page list and in the Protocol Group Index.

3. (Optional) Review and revise the list of protocols that are included:
   1. Click List.

      A table is added to the bottom of the page, which lists the protocols.

   2. Select the appropriate domain from the Domain list, if custom protocol names have been defined.

      For more information about the Domain setting, see Step 3 in Configure the Protocol Group.

   3. Click Add/Remove and change the contents of the protocol group as needed

      For more information about this step, see Step 4 in Configure the Protocol Group.

   4. Click Done when you finish configuring the contents of the protocol group.

   The protocol group is configured with your settings. As soon as the next synchronization in CA Performance Center is complete, the revised protocol group is available to operators who are defining an Analysis or Custom report.