Display Options

Display options are used to display information about nodes. The actions can be entered as follows:

Note: To display all available actions on a node, enter ? next to the node.

You can use the following actions to display all node types:

S: Displays the selected node and a list of its subordinate nodes.
SA: Displays the selected node and a list of its active subordinate nodes.
SI: Displays the selected node and a list of its inactive subordinate nodes.
SN: Displays the selected node only, without subordinate nodes.

You can use the following actions to display clusters:

SC: Displays the selected node and a list of its subordinate clusters.
SAC: Displays the selected node and a list of its active subordinate clusters.
SIC: Displays the selected node and a list of its inactive subordinate clusters.

You can use the following actions to display lines:

SL: Displays the selected node and a list of its subordinate lines.
SAL: Displays the selected node and a list of its active subordinate lines.
SIL: Displays the selected node and a list of its inactive subordinate lines.

You can use the following actions to display link stations:

SS: Displays the selected node and a list of its subordinate link stations.
SAS: Displays the selected node and a list of its active subordinate link stations.
SIS: Displays the selected node and a list of its inactive subordinate link stations.

You can use the following actions to display terminals:

ST: Displays the selected node and a list of its subordinate terminals.
SAT: Displays the selected node and a list of its active subordinate terminals.
SIT: Displays the selected node and a list of its inactive subordinate terminals.

You can use the following action to display a cross-domain resource:

Note: This command applies to nodes of type CDRSC only.

You can use the following action to display SNA status code details:

Note: This option is not available from summary displays.

You can also use actions that result in VTAM commands to display nodes. These are entered as actions in the same places as display options.

The actions in the following table are the list of valid system actions and the VTAM commands generated for displaying nodes.

Action	VTAM Command Generated	Result
D	D NET,ID=nodename,E	Displays the node and the name and status of all its subordinate nodes.
DA	D NET,ID=nodename,A	Displays the node and the name and status of all its active subordinate nodes.
DEN	D NET,ID=nodename,EN	Displays the node in a Fujitsu VTAM-G environment.
DES	D NET,ID=nodename,ES	Displays the node set in a Fujitsu VTAM-G environment.
DI	D NET,ID=nodename,I	Displays the node and the name and status of all its inactive subordinate nodes
DN	D NET,ID=nodename	Displays the node only. Does not display any subordinate nodes.

Note: The DEN and DES actions are valid only in a Fujitsu VTAM-G environment.