Step 4 – Verify Target Data Set Names

Customization › Customization Steps › Step 4 – Verify Target Data Set Names

Step 4 – Verify Target Data Set Names

After selecting Step 4, the following panel displays.

CUSTPT04 ---- PMA V90 Customization - Verify PMA Target DS Names -------------- COMMAND ===> Please verify the names of the PMA Target Data Set Names: REXX Library (PO) : CAMAT.PMA.CEETEXEC Panel Library (PO) : CAMAT.PMA.CEETPENU Message Library (PO) : CAMAT.PMA.CEETMENU LOAD Library (PO) : CAMAT.PMA.CEETLOAD AUTH Load Library (PO) : CAMAT.PMA.CEETAUTH HELP Library (PO) : CAMAT.PMA.CEETHELP CANCEL: CAN SAVE: ENTER

The panel lists the product libraries that are established through the SMP/E installation process.

Verify that the correct data set names are listed.
If the listed names are incorrect, type the correct names that the product libraries were created with in this panel.

Choose one of the following actions:

Press Enter to save the entered values. Step 4 is marked as COMPLETED, as shown following, and you can continue with Step 5.

CUSTPT00 ------------------- PMA V90 Customization Dialog ---------------
 COMMAND ===> 5
      Step                                                Status
      ===============================================================
       4 Verify PMA Target Data Set Names                 COMPLETED

Specify CANCEL to go back to the Customization Main Menu without saving any entered value. The status of Step 4 stays NOT COMPLETED.