Connector Guides › Connectors Guide › Connecting to Endpoints › RSA ACE (SecurID) Connector › Connector-Specific Features › Token Management › RSA Tokens Property Sheet › Token Operations Tab › Set Emergency Mode On

Set Emergency Mode On

Perform the following procedure to run the set emergency mode on operation.

From the Token Operation Tab

1. Select Emergency Mode On from the Operations field drop-down list.

   The Set Emergency Mode On controls are activated.

2. Enter the temporary password in the Temporary Password field to be used during the emergency operation.
3. Enter the length in the Life time field, in hours, that the emergency mode will be in effect.
4. Check the Auto not lost check box if the token should not be declared lost during emergency mode. If the check box is not selected, the token will be declared lost during the emergency operation.

   Note: Auto not lost is only available for RSA 6.1 or higher.

5. Click Apply/OK to turn Emergency Mode on.

   The Set Emergency Mode On operation is performed.