Connector Guides › Connectors Guide › Connecting to Endpoints › RSA ACE (SecurID) Connector › Connector-Specific Features › Token Management › RSA Tokens Property Sheet › Token Operations Tab › Set New PIN Mode

Set New PIN Mode

Perform the following procedure to run the set new PIN mode operation.

From the Token Operation Tab

1. Select Set New PIN Mode from the Operations field drop-down list.

   The Set New PIN Mode controls are activated.

2. Check the Clear PIN check box if the PIN for the token is to be cleared immediately.

   A new PIN must be assigned the next time you log in with your token code. Your current PIN will not work.

   If the Clear PIN check box is not checked, the PIN is cleared when you log in again with you current PIN and token code.

3. Click Apply/OK to put the token into new PIN mode.

   The Set New PIN Mode operation is performed.