Connector Guides › Connectors Guide › Connecting to Endpoints › Microsoft Exchange Connector › Privileges Required to Connect to the Exchange Endpoint › Configure Exchange 2010 Endpoints

Configure Exchange 2010 Endpoints

This procedure is for the Exchange administrator.

Follow these steps:

1. Ensure that Microsoft Exchange 2010 Management Tools is installed on each endpoint.
2. Enable PowerShell remoting on the Exchange 2010 endpoint that you intend to use as the Exchange Gateway Server.
3. Set up authentication for the remote PowerShell session, using the following instructions:
   • Set Up HTTP Basic Authentication
   • Set Up Kerberos Authentication