Connector Guides › Connectors Guide › Connecting to Endpoints › HP NonStop SAFEGUARD Connector › Installing the HP NonStop SAFEGUARD Agent › Step 2. Configure Your System › Run the Agent Processes

Previous Topic: Step 2. Configure Your System

Next Topic: Common Communication Interface (CCI) Installation for HP NonStop Safeguard

Run the Agent Processes

To manage your HP NonStop SAFEGUARD endpoints, you must run the agent processes. Perform the following procedures to start the agent processes:

From the TACL prompt on your HP NonStop SAFEGUARD system

  1. Log on as SUPER.SUPER.
  2. Issue the following commands: 
    instvol.CARELSCR.CONNECT
    instvol

    The disk volume where the HP NonStop SAFEGUARD agent is installed.

    CASTART ALL
  3. To stop the agent processes, type the following command: 
    CASHUTDOWN ALL