Installing Your Product from Tape › How to Install Products Using Native SMP/E JCL › Prepare the SMP/E Environment for Tape Installation

Prepare the SMP/E Environment for Tape Installation

The members that are used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA IPC.

Before you begin this procedure, confirm whether your product uses UNIX System Services (USS). If it does, establishing a hierarchical file system (HFS) may be required as part of the product installation or required as a feature of the product.

For information about the members, see the comments in the JCL.

Follow these steps:

1. Customize the macro IPCSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE command. Each time that you edit an installation member, type IPCSEDIT on the command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize your yourHLQ.SAMPJCL members.

   Note: The following steps include instructions to execute the IPCSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the IPCEDALL member.

2. Open the SAMPJCL member IPC1ALL in an edit session and execute the IPCSEDIT macro from the command line.

   IPC1ALL is customized.

3. Submit IPC1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA IPC are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member IPC2CSI in an edit session and execute the IPCSEDIT macro from the command line.

   IPC2CSI is customized.

5. Submit IPC2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.