Previous Topic: How to Install Products Using Native SMP/E JCLNext Topic: Run the Installation Jobs for a Pax Installation

Installing Your Product from Pax-Enhanced ESD › Receiving the SMP/E Package › Prepare the SMP/E Environment for Pax Installation

Prepare the SMP/E Environment for Pax Installation

The members in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA IPC. External DDDEF data sets are required. The default is NULLFILE.

Prior to beginning this procedure, confirm whether your product uses UNIX System Services (USS). If it does, establishing a hierarchical file system (HFS) may be required as part of the product installation or required as a feature of the product.

For information about the members, see the comments in the JCL.

To prepare the SMP/E environment for your product

  1. Customize the macro IPCSEDIT with your site-specific information and then copy the macro to your syslib location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type IPCSEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

    The macro is ready to customize the yourHLQ.SAMPJCL members.

    Note: Set the DASDHLQ to the same value specified for yourHLQ for the unzip to DASD ESD JCL.

    Note: The following steps include instructions to execute the IPCSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the IPCEDALL member.

  2. Open the SAMPJCL member IPC1ALL in an edit session and execute the IPCSEDIT macro from the command line.

    IPC1ALL is customized.

  3. Submit IPC1ALL.

    This job produces the following results:

  4. Open the SAMPJCL member IPC2CSI in an edit session and execute the IPCSEDIT macro from the command line.

    IPC2CSI is customized.

  5. Submit IPC2CSI.

    This job produces the following results: