Previous Topic: Replacing the COPY Parameters For Tape Input (z/VSE only)Next Topic: Interval Monitor Batch Reports

Preparing to Run Reports › Note For DDR-Only Shops

Note For DDR-Only Shops

DDR-only shops must use the CULPRIT USE statement to request the following reports:

Instead of using the =COPY statement, as demonstrated by the examples earlier in this section, use the following:

PMIRPT00

                                                      PMCULLID for z/VSE
USE  'PMIRPT00'                                       ▼
CHANGE 'IN 80'                    TO 'IN 363 V 367 UM(PMCULLIM) $'
CHANGE 'REC FILE1-EOF'            TO 'REC FILE1-EOF 283 1 2 $'
CHANGE 'CARD-REC 1'               TO 'CARD-REC 284'
CHANGE 'CARD-GRP 1'               TO 'CARD-GRP 284'
CHANGE 'IN 280'                   TO '00$'
CHANGE 'IN 285 F 285 PS MB=DUMMY' TO 'IN 285 F 285  MB=DUMMY'
CHANGE 'IN 457 F 457 PS MB=DUMMY' TO 'IN 457 F 457  MB=DUMMY'
CHANGE 'IN 301 F 301 PS MB=DUMMY' TO 'IN 301 F 301  MB=DUMMY'
USE   'PMNAME'
USE   'PMIRPTnn'     ◄ Specify the required report(s)
USE   'PMIRPT99'     ◄ Optional

PMARPT00

                                                      PMCULLID for z/VSE
USE  'PMARPT00'                                       ▼
CHANGE 'IN 80'                    TO 'IN 363 V 367 UM(PMCULLIM) $'
CHANGE 'REC FILE1-EOF'            TO 'REC FILE1-EOF 283 1 2 $'
CHANGE 'CARD-REC 1'               TO 'CARD-REC 284'
CHANGE 'CARD-GRP 1'               TO 'CARD-GRP 284'
CHANGE 'IN 280'                   TO '00$'
CHANGE 'IN 496 F 496 PS MB=DUMMY' TO 'IN 496 F 496 MB=DUMMY'
USE   'PMNAME'
USE   'PMARPTnn'     ◄ Specify the required report(s)
USE   'PMARPT99'     ◄ Optional

For more information:

For more information about the reports, see Interval Monitor Batch Reports, and Application Monitor Batch Reports. For more information about the USE statement, see the CULPRIT Reference.

z/OS blocksize considerations

The input JCL for the statistics input file (SYS011) must specify a DCB=BLKSIZE=nnnnn parameter. Nnnnn must be at least 280 bytes larger than the actual block size of the file. If the DCB specified is not large enough, CULPRIT may receive an 0C4 abend.

Example:

If the input file has a blocksize of 11476, an appropriate SYS011 DD statement is:

//SYS011 DD DSN=PM.STATS,
//          DISP=OLD,DCB=BLKSIZE=12000