Preparing to Run Reports › Replacing the COPY Parameters For Tape Input (z/VSE only)

Replacing the COPY Parameters For Tape Input (z/VSE only)

Archive log tapes created under z/VSE have a blocksize of 32760, unless file overrides are specified in the SYSIDMS parameters. Therefore, make the changes described in this section to run Performance Monitor reports with tape input. If SYSIDMS file overrides have been used, substitute that blocksize for 32760.

Changing PMARPT00

Replace the COPY parameters in your job stream with USE and CHANGE statements, as follows:

USE 'PMARPT00'
CHANGE ' IN 280 V 6000 '  TO ' IN 280 V 32760 '
USE 'PMNAME'
USE 'PMARPTXX'  specify the required report(s)

Changing PMIRPT00

Replace the COPY parameters in your job stream with USE and CHANGE statements, as follows:

USE 'PMIRPT00'
CHANGE ' IN 280 V 6000 '  TO ' IN 280 V 32760 '
USE 'PMNAME'
USE 'PMIRPTXX'  specify the required report(s)