This chapter lists all messages generated by CA IDMS/DB Reorg that appear in the Audit Report and on the Status Display. All messages listed in the Audit Report are preceded by a unique eight-character code. The message code is in an xxxxnnns format, wherexxxx is the ID of the module issuing the message, nnn is a number for the message within the module, and s is the severity code for the message. The severity code is either I, W, or E. Severity codes are explained below. Condition codes are explained on the following page.
(I) Informative--A message with a severity code of I is an informative message. Informative messages need no remedial action.
(W) Warning--A message with a severity code of W is a warning message. Warning messages report conflicting parameter data or various processing conditions.
In most cases, when a warning message is issued, CA IDMS/DB Reorg finishes executing the step in which the warning was generated, but it will not execute any subsequent reorganization steps. If the warning refers to an invalid value in a parameter statement, CA IDMS/DB Reorg executes the Analysis step so that you receive an Audit/Analysis report.
(E) Error--A message with a severity code of E is an error message. An error message reports an unrecoverable condition. In most cases, when CA IDMS/DB Reorg encounters an error, all processing terminates immediately. If the error is syntactic or semantic, however, CA IDMS/DB Reorg continues processing until it reaches the end of the current step.
This section contains the following topics:
VSE/ESA File Processing Alternate Method
|
Copyright © 2014 CA.
All rights reserved.
|
|